Hidden Wireless Charging in my Desk

After getting a set of AirPods this year I thought it would be nice to have wireless charging at my desk. I like using the touch pad on my MacBook pro, so this mouse pad drawer doesn’t get used and I got the idea to embed a charger in it.

img_2886.jpg

I bought a cheap $10 wireless charger.

img_2887

It won’t charge very quick, but it doesn’t have to when I’m sitting there working most of the day. I figured it would be a fun project and the worst that could happen is I fail and I’m out $10. I opened up the case and there wasn’t much to it.

img_2888

Then there was only one small screw to remove and the electronics were free.

img_2889

img_2890

I forgot to take any other pictures until I had put everything back together. After pulling up the top of the mouse pad, there was some foam underneath. I traced the electronics and USB cable to make a cut out in the foam. Then I used a chisel to carve out the particle board until there was a deep enough recess. I drilled a few holes for wires and the LED. I had cut the LED off of the circuit board so I could route it to the front of the drawer. I soldered on some wires to connect the LED back to the board, hot glued everything in place, and then used super glue to put the mouse pad top back on. Overall it was an ugly hack job. Over to the right is a picture of the holes and wiring underneath.

Check out this short video of the charging in action.

BTW, the mouse pad drawer has two identical halves, so if I ever decide to use a mouse again (it’s been at least 5 years since I had one), I’m good to go.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s