Air Tool Organization

I’d been thinking about getting a better cordless brad nailer because the old Craftsman one I have is useless. I discovered Craftsman makes a much better one in the C3 line, but it runs about $130. I kept looking around and found Home Depot selling a Porter-Cable combo kit with:

  • 6 Gallon 150 PSI Air Compressor

  • 16-Gauge Nailer

  • 18-Gauge Nailer

  • 3/8″ Stapler

  • 25′ Hose

It was down to $200 from $279! I bought it the next morning. I also stopped by Harbor Freight for their air tool accessory kit (gotta have a blow gun!) and a secondĀ 25′ hose.

I didn’t want the compressor in the shop because it’s very loud when it runs. So I cut a hole through the wall, put in an electrical box, and added a face plate so it doesn’t look too much like a hack job. If I ever move it I can swap out the place for a blank one.

compressor-through-wall

Where it comes through on the other side is under my staircase, which is fairly central in the shop. Figured that would be a good place to store the tools.

air-tool-storage.jpg

I didn’t want to have to go to the other room to turn the compressor on/off. So I removed an old outlet that was on this wall, added a 2-gang electrical box, put in a new outlet, and wired a switch to control the bottom plug (top plug stays hot). Now I can always leave the compressor’s power switch turned on.

%d bloggers like this: